
3671 ORP CONTROLLER

- Automatic temperature compensation 0-100° C
- Set points on front panel
- Large bright red LED screen
- Easy to install
Listing Details
Global Water's ORP Controller is a 1/8 DIN panel mount controller with dual SPDT Hi/Lo relays, manual set points and calibration potentiometers set into the front of the panel. The ORP controllers feature a voltage/recorder output and an internal ORP select switch. The ORP Controller's display is a large 0.56 inch high efficiency bright red LED. The ORP Controller's sensor connectors are a BNC input and spade lug screw type connector block. The ORP Controller requires a Pt-100 ATC probe or a simulation resistor for temperature. The ORP controllers use an all solid state design to achieve low power consumption and reduced internal heating. Each ORP controller is heat cycled 100 hours before shipment. The ORP controller offers automatic pH temperature compensation from 0 to 100°C and set points that cover the entire ORP sensor span. |
ORP Controller Range: pH: 0 to 14.0 Temp: 32.0 to 212.0 °F (0.0 to 100.0 °C) mV: -1990 to +1990 ORP Controller Resolution: pH: 0.1 Temp: 1.8 °F (1 °C) mV: 10 ORP Controller Accuracy: pH (+ digit): 0.1 (relative) when standardized within 2 pH Temp (+ digit): 1 mV (+ digit): +0.1 % Input Impedance: >1012 ohms Temperature Compensation: Auto 32.0 to 212.0 °F (0.0 to 100.0 °C) Recorder Output (Full Range): pH: 1400 mV Temp: 1000 mV mV: + 1990mV Dual point ON/OFF control: pH or ORP with internal select switch Dead Band: + 0.1 pH for each set point Relay Output: 8 Amp at 115 VAC, 4 Amp at 230 VAC Readout: 0 .56" high efficiency red LED display Power Source: 115 VAC, 230 VAC + 15% 50/60 Hz Dimension: 3.75x2x6.75 inch (96x48x172mm) Weight: 1.5 lbs (0.69 kg) |